Filter
Top Products
20 www.pridemobility.com Jet 10/Rev H/Feb03
Figure 9. Charger Connector
V. ASSEMBLY
Figure 8. Seat Installation
Figure 7. Seat Tower
To reduce the possibility of shipping damage, your Jet
10s seat is removed from the power base. The joystick
may also have been removed from the armrest. The fol-
lowing is a set of instructions to help you quickly and eas-
ily prepare your Jet 10 for immediate use.
SEAT INSTALLATION
To install the seat:
1. Set the seat on the seat tower. See figures 7 and 8.
2. Push the seat down until the latch engages.
3. Plug in the charger connector and the 9-pin controller
connector into the power base. See figures 9 and 10.
The charger connector is coded with colored dots. The
dots are positioned so that the flat side of the male
connector aligns with the flat side of the female connector
while making the connection.
WARNING! Failure to properly align the con-
nectors can result in damage to the control-
ler, the charger, and the connectors.
JOYSTICK INSTALLATION
Your Jet 10 is equipped with a Dynamic DL joystick control-
ler. It may have been shipped without the joystick installed in
the armrest.
To install the joystick controller:
1. Use a 3/16-in. hex key to loosen the setscrew. See figure
11.
2. Slide the joystick mounting arm into or out of the armrest
bracket to the desired position.
3. Retighten the setscrew by turning it clockwise.
CAUTION! Do not place the controller cable
so that it can be pinched in the seat frame or
the power base frame.
CAUTION
!
Do not pick up the seat frame
by the armrests. They are free to pivot,
and you may lose control of the seat if
they do so, resulting in personal injury or
damage to the chair.