Filter
Top Products
24 Jazzy 1120
2000
VII. DISASSEMBLY
SEAT REMOVAL
You may wish to remove the seat for transportation. If you have a Versa
Seat, please refer to the Versa Seat Installation and Adjustment guide.
To remove the seat:
1. Turn the power off.
2. Make sure your Jazzy is not in freewheel mode.
3. Unplug the main wire harness behind the seat.
4. Simultaneously depress the two plungers on the front of the
seat frame while lifting the front of the seat. See figure 31.
5. Lift the seat up and gently lower it back onto the front seat towers.
6. Pull the seat forward and lift it off of the rear seat towers.
To remove a power seat:
1. Release seat by moving the seat release lever rearward.
2. Lift up the power seat plate.
3. Lift the seat off of the actuator.
FOOT FRAME REMOVAL
The foot frame helps protect the Jazzy components from the envi-
ronment. See figure 32. You must remove the foot frame in order
to change the batteries and check the cable connections.
To remove the foot frame:
1. Turn the power off.
2. Make sure your Jazzy is not in freewheel mode. See IV.
The Jazzy 1120
2000
.
3. Locate the 5/15-in. pin at the base of the footplate bracket
and remove.
Figure 31. Removing the Seat
Figure 32. Removing the Foot Frame
4. Lift the foot frame straight up approximately 2 inches and pull toward you.
WARNING! Your Jazzy 1120
2000
batteries weigh approximately 44 lbs. each. Lifting weight above
your capability could result in injury.
BATTERY REMOVAL
To remove the batteries:
1. Turn the power off.
2. Remove the foot frame.
3. Disconnect the quick disconnects by pulling them toward you.
4. You can now remove the batteries from your Jazzy.