Filter
Top Products
J6 Series www.pridemobility.com 27
UNCLAMPED
BOLT
LEVER (OPEN)
NUT
CAM
LEVER (FULLY
CLOSED)
CLAMPED
V. COMFORT ADJUSTMENTS
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, refer to the controller position
information provided in separate manuals.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to different
heights.
To raise or lower the foot platform:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 20.
2. Remove the cap and loosen the foot platform
securement nut one-half turn.
3. Raise or lower the foot platform to the desired
height.
4. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
5. Tighten the nut to secure.
Foot Platform Depth Adjustment
To adjust the foot platform depth:
1. Remove the quick release fasteners from the foot
platform bracket. See figure 20.
2. Move the foot platform in or out to the desired
depth.
3. Reinstall the quick release fasteners into the foot
platform bracket and tighten.
Quick Release Fasteners: The foot platform is
attached to the power base with two quick release fas-
teners. See figure 20. Each quick release fastener con-
sists of a bolt, a lever, and a nut. See figure 21. The
lever has a cam on the end that allows it to clamp into
place. The quick release fastener has two states:
clamped and unclamped. When the lever is open, the
quick release fastener is unclamped. When the lever is
closed, the quick release fastener is clamped.
To clamp the quick release fastener:
1. Make sure the lever is in the open position.
2. Turn the nut clockwise until it is snug.
3. Rotate the lever until it is in the fully closed position.
NOTE: If the lever will not rotate to the fully closed
position, then turn the nut counterclockwise one-
quarter or one-half turn.
Figure 20. Foot Platform Adjustment
FOOT
PLATFORM
BRACKET
FOOT PLATFORM
RETAINING PIN
QUICK
RELEASE
FASTENERS
Figure 21. Quick Release Fastener Operation
SCREW
SECUREMENT NUT