Filter
Top Products
J6 Series www.pridemobility.com 25
Figure 18. Seatback Angle Adjustment
Figure 17. Seat Position Adjustment
V. COMFORT ADJUSTMENTS
12. Remove each screw from the trapeze bars and apply
thread lock.
13. Reinstall each screw into the trapeze bars and tighten.
14. Reinstall the seat and flip down the seat latch safety.
15. Reconnect the controller connector(s) to the power base.
16. Reinstall the rear shroud and tighten the fasteners.
Seat Position
You can move the seat forward or rearward by changing
the extrusion mounting position.
To change the position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 6.
3. Unplug the controller connector(s) from the power
base.
4. Remove the seat from the power base.
5. Remove both extrusions from the bottom of the seat.
6.
Reposition the extrusions on a different set of mounting
holes. You must move both extrusions the same num-
ber of holes either forward or backward.
See figure 17
.
7. Fasten the extrusions back onto the bottom of the seat.
8. Reinstall the seat.
9. Reconnect the controller.
10. Reinstall the rear shroud and tighten the fasteners.
Manual Recline Seatback Adjustment
If your power chair is equipped with a reclining seat, you
can adjust the seatback angle with the seatback release
lever. The lever is located on the right side of the seat base.
To adjust the recline angle:
1. Pull up on the seatback release lever.
2. Lean forward or backward to the desired position.
3. Release the lever.
Seatback Angle Adjustment
If your power chair is equipped with an adjustable seat-
back, you can adjust it to four (4) different angles: 90°,
102°, 105°, or 107°.
To adjust the seatback angle:
1. Remove the adjusting screws from each seat hinge.
See figure 18.
2. Set the seatback at the desired angle.
3. Reinstall the adjusting screws to each seat hinge and
tighten.
SEATBACK
ANGLE
ADJUSTING
SCREW
ARMREST KNOB
JAM NUT
ARMREST ANGLE
ADJUSTING
SCREW
ARMREST HEIGHT
ADJUSTMENT
SETSCREWS
SEAT MOUNTING HOLES