Filter
Top Products
24 www.pridemobility.com J6 Series
V. COMFORT ADJUSTMENTS
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller
position. If your power chair is equipped with a Specialty Seat, Synergy Seat, or TRU-Balance Power Positioning
System, refer to the information provided in separate manuals. If your power chair is equipped with a medium-
back, a high-back, or a reclining seat, refer to the following information.
WARNING! The center of gravity of your power chair was factory set to a position that meets
the needs of the demographic majority of users. Your authorized Pride Provider has evaluated
your power chair and made any necessary adjustments to suit your specific requirements. Do
not change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to “Appendix I - Specifications” for specific component weights before you
disassemble the power chair.
TRAPEZE BARS
RETAINING
CLIPS
SEAT POSTS
Figure 16. Seat Height Adjustment - Trapeze Bars
SCREWS
SEAT POSTS
RETAINING
CLIPS
WARNING! Remove the occupant from
the power chair before making any
adjustments.
You may need the following to make comfort adjust-
ments:
metric/standard socket set and ratchet
adjustable wrench
thread lock
metric/standard hex key set
Seat Height and Seat Angle Adjustment
You can change the seat height to one of four positions
in 1-in. (2.54 cm) increments by raising the front and rear
trapeze bars. If you raise or lower only one trapeze bar
(front or rear), you can also change the seat base angle
(dump).
To change the seat height:
1. Turn off the power to the controller.
2. Ensure the power chair is in drive mode.
3. Loosen the rear shroud fasteners and remove the rear
shroud. See figure 6.
4. Disconnect the controller connector(s) from the
power base. See figure 7.
5. Flip up the seat latch safety. See figure 15.
6. Squeeze the seat latch and release the seat from the
front trapeze bar. See figure 15.
7. Slide the seat forward and remove it from the power base.
8. Loosen the screws that attach the trapeze bars to the
seat posts. See figure 16.
9. Remove the retaining clips that secure the seat posts
to the power base. See figure 16.
10. Move the trapeze bars up or down to the desired
height.
11. Reinstall the retaining clips from step 8.
Figure 15. Seat Height Adjustment - Seat Latch Safety