Filter
Top Products
Jazzy 600 Series www.pridemobility.com 27
V. COMFORT ADJUSTMENTS
To release the positioning belt:
1. Press the push button mechanism on the plastic housing.
MANDATORY! Make sure the positioning belt is properly secured to the power chair and is
adjusted for operator comfort before each use.
MANDATORY! Inspect the positioning belt for loose or damaged parts before each use of the
power chair. If you discover a problem, contact your Quantum Rehab Provider for maintenance
and repair.
Foot Platform Height Adjustment
The foot platform height is easily adjusted to several different heights.
To raise or lower the foot platform:
1. Remove the hardware from the foot platform bracket.
See figure 19.
2. Raise or lower the foot platform to the desired height.
3. Reinstall the hardware into the foot platform bracket and tighten.
Foot Platform Depth Adjustment
You can adjust the depth of the foot platform.
To adjust the foot platform depth:
1. Remove the hardware from the foot platform bracket.
See figure 19.
2. Move the foot platform in or out to the desired depth.
3. Reinstall the hardware into the foot platform bracket and tighten.
Foot Platform Angle Adjustment
You can adjust the angle of the foot platform.
To adjust the foot platform angle:
1. Flip up the foot platform and locate the screw.
See figure 19.
2. Turn the screw to raise or lower the front of the foot platform.
Positioning Belt
Your power chair may be equipped with a positioning belt that can be adjusted for operator comfort.
See figure 20.
The positioning belt is designed to support the operator so that he/she does not slide down or forward in theseat. The
positioning belt is not designed for use as a restraining device.
To install the positioning belt:
1. Remove the rearmost screw that holds the seat hinge to the seat base on both the left and right seat hinges.
2. Insert the screw through the supplied washer, through the positioning belt and into the seat base for each side of the
power chair seat.
3. Tighten both screws.
To adjust the positioning belt for operator comfort:
1. Once seated, insert the metal tab on one side of the belt into the plastic housing on the opposite side until you
hear a click. See figure 20.
2. Pull the excess strap attached to the metal tab until it is secure, but not so tight as to cause discomfort.
Figure 20. Positioning Belt Adjustment