Filter
Top Products
Jazzy 600 Series www.pridemobility.com 23
TRAPEZE BARS
SCREWS
RETAINING CLIPS
SEAT POSTS
V. COMFORT ADJUSTMENTS
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to
increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller
position.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or TRU-Balance Power Position-
ing System, refer to the seat adjustment information contained in separate manuals.
WARNING! The center of gravity of your power chair was factory set to a position that meets the
needs of the demographic majority of users. Your authorized Pride Provider has evaluated your
power chair and made any necessary adjustments to suit your specific requirements. Do not
change your seating configuration without first contacting Pride Mobility Products or your
authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry
them. Please refer to the specifications table for specific component weights before you
disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort
adjustments:
metric/standard socket set and ratchet
adjustable wrench
thread lock
Seat Height and Seat Angle Adjustment
You can change the seat height to one of four positions
by raising the front and rear trapeze bars. If you raise
or lower only one trapeze bar (front or rear), you can
also change the seat base angle (dump).
To change the seat height:
1. Turn off the power to the controller.
2. Gently push down and pull backward at the harness
access point on the rear shroud until it releases. See
figure 12.
3. Disconnect the controller connector(s) from the
power base. See figure 7.
4. Flip up the seat latch safety. See figure 14.
5. Squeeze the seat latch and release the seat from the
front trapeze bar.
6. Slide the seat forward and remove it from the
power base.
7. Loosen the screws that attach the trapeze bars to the
seat posts. See figure 15.
8. Remove the retaining clips that secure the seat
posts to the power base. See figure 15.
9. Move the trapeze bars up or down to the desired
height.
NOTE: Change the seat dump by raising or lowering
only one set of towers (front or back).
Figure 15. Seat Adjustment - Trapeze Bars
Figure 14. Seat Height Adjustment - Seat Latch Safety