Filter
Top Products
Quantum 6000 Series www.pridemobility.com 27
Figure 19. Adjusting Controller Position (Mounting
Block)
SETSCREWS
MOUNTING SCREWS
MOUNTING BLOCK
V. COMFORT ADJUSTMENTS
Figure 18. Underside of Armrest
Controller Position
You can move the controller in toward or out away
from the armrest, or change the position of the control-
ler for either left-hand or right-hand use.
WARNING! Do not place the controller
harness so that it can be pinched in
the seat frame or the power base
frame.
To extend the controller:
1. Flip up the armrest so it is perpendicular to the floor.
2. Loosen the setscrew on the controller bracket. See
figure 18.
3. Slide the controller into or out of the armrest to the
desired position.
4. Tighten the setscrew to secure the controller.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, loosen the setscrews in the
mounting block, slide the controller in or out to the
desired position, then tighten the setscrews. See fig-
ure 19.
To change the controller position:
1. Turn off the power to the controller.
2. Loosen the rear shroud fasteners and remove the
rear shroud.
3. Unplug the controller connector from the power base.
4. Remove any wire ties securing the controller har-
ness to the armrest.
5. Flip up the armrest so it is perpendicular to the floor.
6. Loosen the setscrew on the controller bracket
7. Slide the controller out of the armrest.
8. Loosen the setscrew in the other armrest.
9. Place the controller in the other armrest.
10. Tighten the setscrew to secure the controller.
11. Route the controller harness to the back of the power
base and plug in the controller. See figure 13.
12. Replace the rear shroud and tighten the fasteners.
13. Secure the controller harness to the armrest with
wire ties. See figure 13.
NOTE: If your power chair is equipped with a Spe-
cialty Seat, Synergy Seat, or TRU-Balance Power
Positioning System, loosen the mounting screws in
the mounting block, transfer the mounting block and
controller to the opposite armrest, and tighten the
mounting screws. See figure 19 .
SETSCREW
CONTROLLER BRACKET