Filter
Top Products
29Jazzy 1103
FIGURE 16. Power Seat Connector
Housing
POWER SEAT SWITCH CON-
NECTOR
POWER SEAT SWITCH
CONNECTOR
Before activating your Jazzy power elevating seat, be sure you are on a flat level surface. To raise the power
elevating seat, push the toggle switch forward. See figure 15. Releasing the toggle switch returns the switch to its
center position and stops upward movement. To continue your lift, push the toggle switch forward again. Once the
seat reaches its highest extension, the lift action stops; you should continue to hear and/or feel the lift motor running.
This is because there is a clutch mechanism that allows the motor to continue running after the lift has reached its
limit. This clutch works at both the top and bottom extensions of the lift. In order to prolong the life of your lift
mechanism, please do not allow the motor to run more than a few seconds after the mechanism reaches the top or
bottom limit. To return the seat to its lowest position, pull the toggle switch toward you. Releasing it stops the
motor. When returning to the lowest position, always be sure that the mechanism has reached its lowest limit.
To use the swivel feature, locate the swivel lever under the seat. It is located on the opposite side of the joystick.
Push down on the lever and the seat can be swiveled 90 degrees.
The following accessories are available from your local Pride provider.
POSITIONING BELT
The positioning belt is designed to support your torso so that you do not slide down or forward in the seat. See
figure 17.
l The positioning belt is not designed for use as a restraining device.
l Make sure the belt is secure but does not cause discomfort.
CAUTION
:
The positioning belt is not designed for use as a seat belt in a motor
vehicle. Nor is your Jazzy 1103 suitable for use as a seat in any vehicle. Anyone
traveling in a vehicle should be properly belted into seats approved by the ve-
hicle manufacturer.
FIGURE 17. Positioning
Belt
VII. OPTIONAL ACCESSORIES