Filter
Top Products
26 Jazzy 1103
VI. CARE AND MAINTENANCE
BATTERY REPLACEMENT
To replace the battery:
1. Turn the power off.
2. Unplug the controller wire harness. See V, Disassembly.
3. Remove the seat.
4. Remove the body shroud.
5. Engage the motor drive assembly. See III, Operation.
6. Remove the 1/2-in. nuts and bolts that fasten the battery cables to the battery.
7. Install the new batteries into the Jazzy 1103 with the terminal sides of the batteries inward facing each other.
8. Connect the wire marked (+) to the closest positive (red) battery terminal.
9. Connect the wire marked (-) to the closest negative (black) battery terminal on the other battery.
10. Connect one circuit breaker harness to the empty positive terminal of one battery and the other circuit breaker
harness to the empty negative terminal of the other battery.
11. Dispose of your old batteries in accordance with your local disposal laws.
MOTOR BRUSHES
The electric motors that power your Jazzy use carbon brushes. These brushes may become susceptible to wear
over a long period of time. The motor brushes are the two contacts located inside the motor assembly that supply
power to the motor. They are designed to provide several thousand hours of operation. But if the brushes become
dirty with carbon deposits or wear out, the motor will run poorly or not at all. We recommend that your authorized
Pride provider inspect the brushes every six months, or sooner if your Jazzy 1103 runs poorly. If inspection
determines excessive wear on the brushes, they must be replaced or motor damage will result.
NOTE
:
Failure to maintain the brushes could void the Jazzy’s warranty.
To inspect or replace the motor brushes:
1. Remove the seat and body shroud. See V, Disassembly.
2. Unscrew the motor brush caps. See figure 13.
3. Remove the brushes.
4. Inspect for wear. See figure 14.
5. Replace the brushes, if necessary. Contact your local authorized Pride provider for replacement brushes.