Filter
Top Products
The cleaning light starts to ash and the shaver is
automatically lowered into the cleaning uid.
The cleaning light ashes throughout the
cleaning program, which takes 4 to 6 minutes,
depending on the cleaning program.
During the rst phase of the cleaning program,
the shaver automatically switches on and off
several times and moves up and down.
During the second phase of the cleaning
program, the shaver is placed in the drying
position, indicated by a ashing drying symbol.
This phase takes approx. 2 hours. The shaver
stays in this position until the end of the
program.
After the cleaning program, the charging
indication appears on the shaver display (see
chapter ‘The display’).
Note: If you press the on/off button of the Jet
Clean System during the cleaning program, the
program aborts and resets. In this case, the cleaning or
drying light stops ashing and the holder returns to its
starting position.
Note: If you remove the adapter from the wall socket
during the cleaning program, the program aborts. The
holder remains in its current position. When you put
the adapter back into the wall socket, the holder moves
to the highest position.
When the uid level drops below the minimum
level, the cleaning light and the ‘cleaning chamber
empty’ symbol start to ash and the holder
returns to its starting position.
If you use the washing machine to clean your
shaver every day, you need to rell the cleaning
chamber approx. every 15 days.
,
,
,
,
,
-
-
ENGLISH 19