Filter
Top Products
4 To make sure you brush evenly throughout the mouth, divide
your mouth into 4 sections: outside upper teeth, inside upper
teeth, outside lower teeth and inside lower teeth. Begin brushing
therstsection(outsideupperteeth)andbrushfor30seconds
before moving to the next section (inside upper teeth). Continue
brushing the other two sections for 30 seconds each until you have
completed the 2-minute brushing cycle.
5 Afterthe2-minutebrushingcycle,youcanbrieyswitchon
the Sonicare again to brush the chewing surfaces of your teeth.
Press the on/off button to switch the Sonicare on or off as needed.
To clean your mouth more completely, you can also brush your tongue
with the toothbrush switched on or off, as you prefer.
Stain removal
For even better stain removal, dedicate a few seconds of extra brushing
time to areas where excess staining occurs.
Braces
Place the brush head at a 45-degree angle between the brackets and the
gumline. Using light pressure, gently move the bristles in a small circular
motion so the longer bristles reach between your teeth for 2 seconds.
Then gently roll the brush handle so the bristles clean the bracket and
the rest of the tooth. Subsequently pass the bristles to the next tooth.
Continue this procedure until you have brushed all your teeth. Please note
that brush heads wear out sooner when used on braces.
Dental restorations
Use the Sonicare on dental restorations (such as implants, caps, crowns,
bridges and llings) as you do on your natural tooth surfaces. Work the
bristles round all the areas of the restoration for thorough cleaning.
Periodontal pockets
Your dentist or dental hygienist may have indicated that you have
periodontal pockets, deep pockets where plaque bacteria collect. If this is
the case, spend extra time brushing these areas after you have completed
the 2-minute brushing cycle to improve your gum health.
Features
Easy-start
All Sonicare models come with the Easy-start feature activated,
which helps you get used to brushing with the Sonicare.
Thebrushingpowergentlyincreasestofullpowerovertherst
12 brushings.
The Easy-start feature is active if you hear 2 beeps immediately after
you switch on the Sonicare. Once the Sonicare has reached optimal
brushing power (after the 12th brushing), you no longer hear the
2 beeps at the beginning of each brushing cycle.
Note:Each of the rst 12 brushings must be at least 1 minute long to move
properly through the Easy-start ramp-up cycle.
To deactivate or activate the Easy-start feature:
1 Attach the brush head to the handle.
,
,
,
,
,
,
,
1
2
4
3
1
2
4
3
ENGLISH 7