Filter
Top Products
ENGLISH 17ENGLISH16
Charge Meter
◗ Charge Meter monitors amount of remaining
battery power and actual remaining shaving
minutes available. ‘Minutes Left’ is based on
the amount of power consumed shaving per
minute and is dependent upon your skin and
beard type, whether you use pre-shave lotion,
and how often the trimmer is used.
◗ Initially your razor may need to go through 2
or 3 full charge/recharge cycles before
“Minutes Left” indicator (numeric or battery)
begins to display your accurate“Shaving
Minutes Left.”
Before First Use
◗ Charge the razor before you start using it
(see ‘Charging’). Make sure the razor is
switched off before you start charging it.
◗ Remove any sticker or protective foil from
the LCD Display before using razor.
Important
◗ Only use the power plug and/or
Jet Clean
System
provided to charge the razor.
◗ The charging plug converts 100 – 240V AC to
less than 24V DC.
Charging
◗ Battery performance is best if you recharge
only when the batteries are (almost)
completely empty.
◗ Charging or recharging at temperatures below
40ºF or higher than 95ºF adversely affects
lifetime of batteries.
◗ Continuously recharging or continuously using
as a corded razor will reduce life of batteries.
◗ You may also shave using the cord provided.
This razor will not recharge while being used
corded.
◗ Do not charge razor in a pouch.
◗ Recharge only when the plug symbol starts
blinking.This symbol may appear when your
razor is ON or OFF.
◗ Do not charge/recharge or use razor corded
until fully dried.
Charging Razor with a Cord
C 1 Connect cord directly to razor and
connect the charging plug into any 100V to
240V AC outlet. Use only the charging plug
provided.
◗ An adaptor plug may be necessary for
charging plug usage in some foreign countries.
Use an attachment plug adaptor of the proper
configuration for the power outlet.
The charging plug will automatically convert to
work on 100V to 240V AC systems.