Filter
Top Products
ENGLISH 15ENGLISH14
C ◗ Cleaning Indicator
The blinking faucet symbol will remind you that
razor heads need to be cleaned.This happens
after each shave.
C ◗ Replacement Head Indicator
Every year, depending on your shaving behavior,
after turning the razor OFF, the replacement
head symbol indicator starts to blink. It will
remain visible for the next 7 shaves to remind
you that with new shaving heads you will
guarantee yourself optimal shaving
performance.
◗ You can reset the razor by pressing the
ON/Off button for 3 seconds while the
replacement head symbol is blinking. The
symbol then disappears.
◗ If you do not reset the razor, after 7 shaves
the razor will automatically reset itself.
NO
TE:
If the display shows the w
ord ‘CHECK’ and
a blinking replacement head symbol and faucet
symbol, clean the r
azor thoroughly bef
ore you
continue sha
ving (see ‘cleaning’).
After cleaning, if
the word
‘CHECK’ and a blinking replacement
head symbol and faucet symbol remain on the
display, immediately replace the razor heads (see
‘replace the razor heads’).
◗ Low Battery Indicator
C - The Numeric Display:
When the battery is running low, the plug
symbol and the minutes indicator will blink
after you have turned the razor OFF. If this
occurs while shaving, you should have enough
power to complete your shave.When you turn
razor ON or OFF the display will come on for
approximately 10 seconds.
C - The Battery Display:
When the battery is running low, the plug and
battery symbols will blink after you turn
razor OFF.When you turn razor OFF or ON
the display will stay on for approximately
10 seconds.
C ◗ Battery Empty
To indicate that the battery power is too low
to operate the razor,‘Lo’ appears on the display.
◗ Demonstration Program
The razor has a demonstration program that
will run through the display of razor functions.
During the demonstration the razor will
automatically turn ON and OFF 2 times. To
activate, press and hold the ON/OFF button
for approximately 6 seconds. After 3 seconds
the lock symbol appears; keep the ON/OFF
button pressed.Then release the button and
the razor will continue through the
demonstration program.You can interrupt the
demonstration by pressing the ON/OFF
button again.