Filter
Top Products
ENGLISH 23ENGLISH22
◗ When the cleaning solution level drops below
the minimum level,the cleaning light will blink
with intervals and the razor holder will move
to the starting position.
◗ If you clean your razor every day,you should
refill the canister approximately every 15 days.
C 5 Carefully lower the appliance back onto
the Jet Clean canister making sure the
release buttons snap back into place.
Jet Cleaning the Razor
◗ If the razor does not contain enough power
for one (1) shave,the Jet Clean Cleaning
System may not work properly. Charge the
razor in the Jet Clean System before using it
to clean your razor.
◗ The cleaning cycle takes approximately 1 hour
to complete.
C 1 Connect the small plug to the Jet Clean
System. Connect the charging plug into
any 100V to 240V AC outlet. Use only the
charging plug provided.
The razor holder automatically moves up to the
highest position.
2. Place the Jet Clean System on a flat, level
surface. Fill the cleaning canister with
cleaning solution (see ‘Preparing Jet Clean
System For Use’).
C 3 Remove protective razor head cap from
razor.
C 4 Place the razor head side down in the
razor holder so that the razor head fits
into the configuration shown inside the Jet
Clean System. Gently press the base of the
razor towards the back of the Jet Clean
System so that the razor base fits snugly in
place. Lock the razor into place by pushing
the lever down completely.
The charging light will blink to indicate the razor
automatically begins to charge.
C 5 Press the ON/OFF button to start the
cleaning cycle.
The cleaning light on the Jet Clean System starts
blinking and the razor is automatically lowered
into the cleaning solution.The razor stops
charging while it is cleaning.
◗ During the first phase of the cleaning
cycle, the razor will automatically turn on and
off several times while the razor holder
lowers and raises the razor’s position in the
cleaning solution,removing all debris. The
cleaning light will blink continuously.
◗ During the second phase of the cleaning cycle,
the razor holder moves the razor to the
drying position and the cleaning light will light
up continuously.