Philips 700 Electric Toothbrush User Manual


 
6 Begin brushing in section 1 (outside upper teeth) and brush for
30 seconds before you move to section 2 (inside upper teeth).
Continue brushing in section 3 (outside lower teeth) and brush for
30 seconds before you move to section 4 (inside lower teeth).
7 After you have completed the brushing cycle, you can
spend additional time brushing the chewing surfaces of your teeth
and areas where staining occurs. You can also brush your tongue,
with the toothbrush switched on or off, as you prefer.
The Sonicare is safe to use on:
Braces (brush heads wear out sooner when used on braces)
Dental restorations (llings, crowns, veneers)
Note: You can switch off the toothbrush at any time by pressing and holding
the on/off button for 2 seconds.

The Clean and White mode consists of 2 minutes of Clean mode to clean
the whole mouth and an additional 30 seconds of White mode to focus on
the visible front teeth.
1 Brush the rst 2 minutes as instructed in steps 1-6 above.
2 After the 2 minutes of Clean mode, the White mode begins with
a change in brushing sound and motion. That is your signal to start
brushing the visible upper front teeth for 15 seconds
3 At the next beep and pause, move to the visible lower front teeth
for the nal 15 seconds of brushing.

The Sonicare automatically starts in the default Clean mode. To select a
different brushing mode:
1 Press the on/off button to toggle between modes.
The green LED indicates the selected mode.
Note: You can only switch between modes when the toothbrush is switched on.

Standard mode for superior teeth cleaning.

Gentle yet thorough cleaning for sensitive gums and teeth.

2 minutes of Clean mode with an additional 30 seconds of White mode to
focus on the visible front teeth.
Note: When the Sonicare is used in clinical studies, the default 2-minute Clean
mode must be selected. However, in whitening/stain reduction studies, the
Clean and White mode must be selected. The handle should be fully charged
and the Easy-start feature deactivated.
-
-
,
1
2
4
3
1
2
4
3
ENGLISH 7