Filter
Top Products
27Philips Lifeline 6900/6800/AT Series User’s Manual
Personal Help Button
Setting Up a New Personal Help Button
If you receive a new Personal Help Button from Lifeline,
you may need to set it up to work with your Lifeline
Communicator. If so, please complete the following steps:
1. With the POWER switch on the back of your Communicator
in the ON position, and the new Personal Help Button in
hand, PRESS DOWN and HOLD DOWN the Reset Bar.
The Communicator will announce: “Start Test.”
2. While still holding down the Reset Bar with one hand,
PRESS DOWN and HOLD DOWN the button on
the Personal Help Button until your hear a long beep and
the Communicator announces: “Personal Help Button,
code XXX, programmed.” This will indicate that the
Communicator has learned the new button and is ready
for use with it. Then release the Reset Bar, and PRESS it
DOWN briefly. The Communicator will beep three times
and then announce: “End Test. There is one Personal Help
Button now programmed. Ready.”
3. If you have two Personal Help Buttons in the home and are
only replacing one of them, you will still need to set up both
buttons when you are setting up the new button. Be sure to
set up both buttons during the same setup process. If you
have successfully set up two buttons, the ending message will
be: “End Test. There are two Personal Help Buttons now
programmed. Ready.”