Filter
Top Products
12 C2453M-C (7/05)
How to Control the Positioning System Using the
Handheld
The Spectra III, Esprit, and ExSite utilities are installed on the handheld contained in this kit. The
handheld is ready for immediate use.
Before using the handheld to control a system, know how to operate the handheld. For instructions on
how to operate the handheld, refer to the manual shipped in the handheld box.
1. Turn the handheld ON.
2. Tap the application icon.
Figure 9. Handheld Main Menu
3. Select the protocol for the system and then enter the system address.
IMPORTANT: The handheld will not operate systems using P protocol address 1. To control the
system with the handheld, change the P address to 2 or higher.
Figure 10. Spectra III Menu
NOTE: If you normally use Coaxitron
®
, you may need to assign a D protocol address to use the
interface cable (IPS-CABLE).
4. Tap the PTZ button.
APPLICATION
ICON
DOME
ADDRESS
SELECT
PROTOCOL
PTZ
BUTTON