Filter
Top Products
8
English
Cleaning the shaver
• Each time you press [SELECT], the course changes from “Clean/
Dry/Charge”“Clean/Dry”“Dry/Charge”“Dry”“Charge”.
• The courses start approximately 6 seconds after they are
selected.
• The course will be aborted if the power is cut off. In this case,
perform the course again from the beginning.
• Do not detach the detergent cartridge or the water tank as the
cleaning liquid may spill causing a malfunction.
1
2
Insert the appliance
plug.
Plug in the adaptor.
Remove the
protective cap and
then attach the
shaver.
• Turn the shaver off before
attaching.
• Check that the outer foil is not
deformed or damaged when
you are attaching the shaver.
Press [SELECT] to select the course.
Course
Course selection indications
Course completion summary
On recharger
Changeable course
halfway through
On recharger On shaver
Time required (guide)
[In the low temperature]
clean dry charge clean dry charge Backlight
Charge
*
Blinks 1 hour
Clean/Dry/Charge
Blinks 2 hours [+30 min]
Clean/Dry
– 1 hour [+30min ]
Dry/Charge
Blinks 2 h 40 min
Dry
– 1 h 40 min
*The lamp goes out in 6 seconds.
• Remove any soap or water
on the shaver if it has been
washed with hand soap or
any other detergent.
ES8228_USA.indb 8 2006/08/21 15:51:42