Filter
Top Products
11
English
Removing the built-in rechargeable battery
Remove the built-in rechargeable
battery before disposing of the
shaver. Do not dismantle or
replace the battery so that you
can use the shaver again. This
could cause fire or an electric
shock. Replace it at an authorized
service center.
1. Disconnect the power cord
from the shaver when removing
the battery.
2. Remove the screw and
remove the bottom cover.
3. Slide the trimmer handle up and remove the screw and
remove the trimmer.
4. Remove the upper rear panel .
5. Remove the screws and remove the back panel.
6. Remove the lower rear panel .
7. Remove the screws and remove the housing .
8. Lift the battery and remove it.
When the water does not drain from the cleaning
tray
Beard trimmings may clog the
drain at the bottom of the
cleaning tray.
In this case, you cannot clean
or dry the shaver.
Push the beard trimmings
down through the drain with a
tooth pick etc.
FOR YOUR CONVENIENCE, WE HAVE ESTABLISHED A TOLL-
FREE (IN USA ONLY) NATIONAL ACCESSORY PURCHASE
HOT LINE AT 1-800-332-5368.
IN CANADA, CONTACT PANASONIC CANADA INC. AT THE
ADDRESS OR TELEPHONE NUMBER ON THE BACK PAGE.
ATTENTION:
A Lithium-ion battery that is recyclable powers the product you
have purchased. Please call 1-800-8-BATTERY for information on
how to recycle the battery.
RBRC
Li-ion
TM
WARNING for Lithium Battery:
Fire, explosion, and severe burn hazard. Do not crush,
disassemble, heat above 100°C (212°F), or incinerate.
drain
ES8228_USA.indb 11 2006/08/21 15:51:45