Filter
Top Products
10
English
Cleaning the self-cleaning recharger
1. Be sure to remove the water
tank and the appliance plug
from the self-cleaning
recharger.
•
Be careful not to spill the
cleaning liquid.
2. Gently wipe off any beard
trimmings attached to the
inside of the cleaning tray with
a cloth or tissue paper
dampened with water.
• Clean the corners and
uneven parts of the
cleaning tray with a cotton
swab dampened with water.
1
2
Beard trimmings may become attached to the cleaning tray of the
self-cleaning recharger. Follow the steps below to remove them.
We recommend doing this each time you change the detergent
cartridge.
• Do not pull hard on the rubber blade protector at the bottom of
the cleaning tray. The rubber may come off if you pull hard on it.
It is only necessary to pull it up slightly.
• Warning - Do not wash or apply water to the adaptor or self-
cleaning recharger. Failure to observe this may cause electric
shock or result in short circuits.
Replacing the system outer foil and the inner
blades.
1. Press the buttons and lift
upwards as illustrated.
2. Remove the inner blades one
at a time as illustrated.
• Do not touch the edges
(metal parts) of the inner
blades to prevent injury to
your hand.
3. Insert the inner blades one at
a time until they click as
illustrated.
4. Insert the system outer foil by
pushing it downwards until it
clicks.
1
2 3
2.3
4
system outer foil once every year
inner blade once every two years
Caution for turbo mode
• Shaving in turbo mode may damage your skin. Turn the shaver
off and then on again to cancel turbo mode.
• Do not place your fingers on the On/Off switch while using the
shaver. This may cause the shaver to turn off or enter turbo
mode. Place your fingers on the finger rest while using the
shaver.
ES8228_USA.indb 10 2006/08/21 15:51:44