Oregon Scientific BPW120 Blood Pressure Monitor User Manual


 
13
EN
INFORMATION ABOUT THE CE MARK
This device complies with the European regulations based
on the Medical Products Code, and bears the CE mark
“CE0120”. The device has been quality inspected according
to EU guideline 93/42/EEC and tested in compliance to the
“EN1060-1 Non-invasive sphygmomanometers – Part 1,
General requirements” and “EN1060-3 Non-invasive
sphygmomanometers – Part 3: Supplementary requirements
for electromechanical blood pressure measuring systems”.
The CE mark further indicates that this blood pressure monitor
meets the general requirements for electronic products as
regards to resistance to electromagnetic interference.
Malfunctioning may however occur in the proximity of
extremely strong electromagnetic fields. In accordance with
the “Ordinance for Operators of Medical Products”, a technical
inspection must be carried out if this device is used for
industrial or commercial purposes.
BLOOD PRESSURE LOG BOOK
To create a log of your blood pressure history, complete the
personal information section at the top, then enter the details
(date, time, and measurements) for each reading you take.
To plot your history, use an S (systolic), D (diastolic) and M
(mean arterial pressure) to mark the points where each
measurement falls on the chart, then connect the points to
view your history over time.
CAUTION
The content of this manual is subject to change
without further notice.
Due to printing limitation, the displays shown in this
manual may differ from the actual display.
—The contents of this manual may not be reproduced
without the permission of the manufacturer.
P/N: 086L003591-148 REV1
Page 14 of 122