Filter
Top Products
6
2.4 FRONT OF THE METER (Continued)
METER BUTTONS
SETPTS Button
In the run mode, press this button to sequentially recall the previous setpoint settings.
After using the
ᮡ
/T1/T2
ᮡ
and
ᮣ
/DEV buttons to alter these settings as desired, press
the SETPTS button to store these new values.
Unless you press the SETPTS,
ᮡ
/T1/T2
ᮡ
or
ᮣ
/DEV button within 20 seconds to
store your input, the meter will scroll to setpoint 2 the return to the run mode.
If the dual relay option is not installed or if the “L.3=1” on the “LK.CF” menu, pressing
the SETPTS button will display the meter's firmware version.
ᮡ
/T1/T2
ᮡ
Button
In the run mode, pressing the
ᮡ
/T1/T2
ᮡ
button will scroll to show T1, T2, and T1-T2.
During the configuration mode or Setpoint modes, use the
ᮡ
/T1/T2
ᮡ
button to
change the values of the flashing digit shown on the display and/or toggle between
menu choices, such as "R.1=F" or "R.1=C". When configuring your setpoint values,
press the
ᮡ
/T1/T2
ᮡ
button to increment the flashing digit from 0 to 9 by 1's.
ᮣ
/DEV Button
In the run mode press the
ᮣ
/DEV button to display the deviation of reading from
Setpoint 1.
In the configuration or setpoint modes, press the
ᮣ
/DEV button to scroll to the next
digit.