Filter
Top Products
Important information
• Always prime your Innovo
®
(as described on page 10-11)
to ensure the insulin flow:
• before each injection
• after changing Penfill
®
• after changing the needle
• after opening and closing the slide
• With a Penfill
®
in Innovo
®
, never
press the push button unless
a needle is mounted.
• Always make sure that the push
button is pressed completely in
and locks.
The display confirms completed
delivery when the segments turn on
two by two and then the circle
appears.
• Do not change the dose after you
have pressed the push button.
• On the Penfill
®
label there is a
coloured band that is unique to the
different types of insulin. When
Penfill
®
is inserted into Innovo
®
, the
coloured band is visible through the
slide. Before each injection make sure
that you are using the right type of
insulin.
• If you are treated with more than
one type of insulin in Penfill
®
3 ml
cartridges, you should use two
devices, one for each type of insulin.
• Do not use the residual scale to
measure the amount of insulin to be
injected.
• Take the needle off Innovo
®
immediately after each injection.
If you do not remove it, temperature
changes may cause liquid to leak
out of the needle. With an insulin
suspension (cloudy insulin), this may
change the concentration of the insulin.
• Do not initiate injection of an insulin
suspension (cloudy insulin) if the rubber
stopper is below the arrow marks on
the slide.
32
æ