Filter
Top Products
6
PATENTS PENDING
If the Lift is dirty, clean it.
DAILY PRE-OPERATION & OPERATION CHECKLIST
NOTE: PRE-OPERATION and OPERATION CHECKS
should be performed by the Lift Operator.
Use Lift operating instructions in this manual to
UNFOLD, LOWER, RAISE, and FOLD platform.
Make sure the Lift responds properly to hand
control switches.
Listen for unusual noises while the Lift oper-
ates.
Watch for uneven movement of the Lift arms,
platform, and inboard and outboard rollstops.
PRE-OPERATION CHECKS
Park vehicle on level ground, shift vehicle
transmission to PARK, and set vehicle emergency
brake before doing the following checks..
Visually check Lift for bent or broken parts, or for
hydraulic fluid around base. Have hydraulic fluid leaks,
and the fluid level in reservoir, checked by a qualified
technician.
Check for hydraulic fluid leaking from cylinders. Lift
may be operated if cylinders are “weeping” a light film
of hydraulic fluid. If hydraulic fluid drips from either
cylinder, have it checked by a qualified technician.
Make sure the ON/OFF switch on the Pump Cover
is turned ON. If indicator on the switch is illumi-
nated, Lift has power to operate.
Check that all Decals are in place, undamaged, and
legible (see DECALS pages).
NOTE: If any of the OPERATION CHECKS have
incorrect indications, discontinue operat-
ing Lift until repairs are performed by a
qualified technician.
NOTE: If any of the PRE-OPERATION CHECKS
have incorrect indications, do not operate
the Lift until repairs are performed by a
qualified technician.
Check that all anti-slip and safety striping is in place
(see ANTI-SLIP & SAFETY STRIPING pages).
OPERATION CHECKS
Operate the Lift through one full cycle to do
the following checks.