Filter
Top Products
18
Measurement
4
Next, it will cause the
file number of the next
measurement to appear.
◆
The measurement data
obtained from power-ON
(start of measurement)
up to power-OFF (end of
measurement) will be stored
in one le.
5
And, if the time for Auto-
Power-Off was set in the
instrument, the setting
time is displayed.
◆
The time for Auto-Power-Off is set by using the optional software.
◆
If the time for Auto-Power-Off has not been set, this step will be
skipped and the measurement display will appear.
Pulse level meter is started to
indicate but the measuring data is
not displayed yet.
The measuring data is calculated
and displayed, and the measurement
is started.
A file number is given to each set
of measurement data (power-ON to
power-OFF). (Maximum: 399 les)
6
About 10 seconds after
the Power is switched
ON, measurements
will be started and the
measurement data at
1-second intervals will
be stored in the memory
of the PULSOX-300i.
◆
“---” is displayed until
the measuring data is
calculated.
<Regarding the measurement data>
The measurement data includes the measurement values (SpO
2
value,
pulse rate, and error message information) and the file information
(file number, date and time of start of measurements, and duration of
measurement).