Support User Manuals

Invacare X-Terminator QR Wheelchair User Manual

Open as PDF

of 76

SECTION 7—FOOTREST/ ANTI-TIPPER

Part No 1114851 63 Everyday and Sport Series Wheelchairs

Installing/Adjusting Optional Clamp on Raised Footrest

NOTE:Forthisprocedure,refertoFIGURE 7.2.

NOTE:ThisprocedureisforTerminatorEveryday(ED)wheelchairsONLY.

Installing

1. Installthetwohalfclampsontoeither

sideofthewheelchairframe

approximately2‐inchesaboveexisting

footrestwithtwoprovidedallen

screws.

2. Repeatfortheoppositesideofthe

wheelchair.

3. Slidetheclamponraisedfootrestinto

thehalfclampstothedesiredheight.

4. Securelytightenthefourallenscrews.

FIGURE 7.2 Installing/Adjusting Optional

Clamp on Raised Footrest

Adjusting

1. Loosenthefourallenscrews.

2. Adjustclamponraisedfootresttothedesiredheight.

3. Securelytightenthefourallenscrews.

Replacing/Adjusting Optional A4 Footrest

NOTE:Forthisprocedure,refertoFIGURE 7.3.

NOTE:ThisprocedureisforTerminatorEveryday(ED)wheelchairsOnly.

Replacing the Footrest

1. Loosen,butDONOTremovethetwoallenscrewsthatsecurethefootresttothe

wheelchairframe.

2. Slidetheexistingfootresttubesoutofthewheelchairframeandinstallnewfootrest

byreversingthisstep.

3. Positionthenewfootresttoadeterminedheight.

4. Tightenthetwoallenscrewsthatsecurethefootresttothewheelchairframe.

5. Adjustthefootplatetothedesiredposition.RefertoAdjustingFootplateAngleon

page 64and/orAdjustingFootplateDepthonpage 64.

Allen

Screws

Wheelchair Frame

Outside

Footrest

Hoop

Half Clamp

Raised

Footrest

previous next