Support User Manuals

Invacare X-Terminator QR Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Part No 1114851 45 Everyday and Sport Series Wheelchairs

FIGURE 5.10 Adjusting Toe In/Toe Out - A4 Camber System - Course Adjustment

NOTE:DONOTtightenthephillipsscrewontheotheradjustmentringatthistime.

NOTE:RepeatSTEPS1‐7ofthisprocedurefortheotheradjustmentringafterrepositioningthe

camberinsert.RefertoAdjustingRearWheelCamberonpage 41.

NOTE:Whenpositioningtheotheradjustmentring,rotatetheringuntilthestopisatthebottom

oftheslotinthecamberclamp.TherightandleftstopsMUSTbepositionedoppositetoeachother

orFineAdjustmentonpage 45willnotworkcorrectly.

NOTE:Whentheleftadjustmentringisadjustedtoacamber,therightadjustmentringwillnot

touchthecamberclampandwhentherightadjustmentringisadjustedtotheothercambertheleft

adjustmentringwillnottouchthecamberclamp.

Fine Adjustment

NOTE:For

thisprocedure,refertoFIGURE 5.11.

NOTE:Thisadjustmentisrequiredanytimethecamberinsertisrepositioned.

1. Openthecamberclamp.RefertoOpening/ClosingCamberClampsonpage 39.

2. Slowlyrotatetheaxletubeuntilthestopontheoppositeadjustmentringispositioned

attheoppositeendofthecamberclamp.

ƽ WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing

towards the rear of the wheelchair and are in the closed position before using the

wheelchair, otherwise personal injury or damage to the wheelchair may occur.

Stop - Not touching

camber clamp

Adjustment Ring

Camber Clamp

Adjustment Ring

Camber Clamp

Stop - In position for one

camber, touching camber clamp

Stop - In position for one

camber, touching camber clamp

Adjustment Ring

Stop - Not touching

camber clamp

Adjustment Ring

previous next