Support User Manuals

Invacare X-Terminator QR Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Everyday and Sport Series Wheelchairs 44 Part No 1114851

A4 Camber System

Course Adjustment

NOTE:Forthisprocedure,refertoFIGURE 5.10.

NOTE:Thisprocedureisrequiredanytimetheaxletubeismovedfromthefactorysetpositionor

isreplaced.

NOTE:Makethefollowingadjustmentforonecamberatatime.

1. Openthecamberclamps.RefertoOpening/ClosingCamberClampsonpage 39.

2. Loosenthephillipsscrewsthatsecuretheadjustmentringstotheaxletube.

3. Slowlyrotatetheaxletubeuntiltherearwheelsareapproximatelyinastraightline.

ƽ WARNING

QUICK RELEASE LEVERS - Make sure the quick release levers are pointing

towards the rear of the wheelchair and are in the closed position before using the

wheelchair, otherwise personal injury or damage to the wheelchair may occur.

ƽ WARNING

STANDARD AND SUSPENSION CAMBER CLAMPS - Make sure the hex screws

are securely tightened before using the wheelchair, otherwise personal injury or

damage to the wheelchair may occur.

4. Closethecamberclamp.RefertoOpening/ClosingCamberClampsonpage 39.

5. Measurethedistancebetweenthecenterlinesattherearandfrontoftherearwheels

atapproximately12inchesfromtheground/floor.RefertoDeterminingToeIn/Toe

Outonpage 42.

6. RepeatSTEPS1‐4untilthetoein/toeoutmeasurementislessthan1/2‐inch(0+

1/4‐inchformaximumrollability).

7. Rotateeithertherightorleftadjustmentringuntilthestopontheringisatthetopof

theslotinthecamberclampasshowninFIGURE 5.10andsecurelytightenthe

phillipsscrewonthepositionedadjustmentring.

NOTE:Rearwheelsareremovedfrom

the

drawingsforclarity.Thereisnoneedtoremove

rearwheelsfromthewheelchairduring

adjustment.

NOTE:FIGURE 5.10showstwoexamplesof

howtheadjustmentringscanbepositioned.

Axle Tube - Rotates Up and Down

previous next