Support User Manuals

Invacare X-Terminator QR Wheelchair User Manual

Open as PDF

of 76

SECTION 5—WHEELS

Part No 1114851 37 Everyday and Sport Series Wheelchairs

7. Ifdetentpindoesnotfullyrelease,proceedtoAdjustingQuad‐ReleaseHandleson

page 37.

8. RepeatSTEPS1‐7fortheoppositerearwheel.

Adjusting Quad-Release Handles

NOTE:Forthisprocedure,refertoFIGURE 5.4.

In and/or Out

1. Removerearwheelandthe

quad‐releaseaxlefromthewheelchair.

RefertoRemoving/InstallingRear

Wheelsonpage 35.

2. Loosenthelockingscrew.

3. Makeoneorbothofthefollowing

adjustments:

•Ifthequad‐releasehandleisnot

releasingthelockingpins

completely,rotatethequad‐release

handleapproximatelyone‐quarter

turnclockwise.

•Ifthequad‐releasehandlehitsthe

spokesof therearwheelwhen

assembled,rotatethequad ‐release

handleapproximatelyone‐quarter

turncounterclockwise.

4. Tightenthelockingscrew.

FIGURE 5.4 Adjusting Quad-Release

Handles

5. Reinstalltherearwheelandquad‐releaseaxleontothewheelchair.Referto

Removing/InstallingRearWheelsonpage 35.

6. Flipthehandleofthequad‐releaseaxledowntoreleasethedetentpinensuringthat

thelockingpinsarefullyreleased.

7. Repeattheaboveproceduresuntilthequad‐releaseaxlelockscorrectly.

Removing Play from Rear Wheels

1. Withtherearwheelandquad‐releaseaxlestillmountedontothewheelchair,makethe

followingadjustment:

•Tightenthelengthadjustingscrewuntilthereisnoinandoutmovementofthe

quad‐releaseaxleandrearwheel.

Adjusting Locknut

(On Quick-Release Axle)

Length

Adjustmen

t

Screw

Removing

Play from

Rear Wheels

Adjusting Quad-Release

Handle In and/or Out

Locking Pins

Camber Bar

Locking

Screw

Quad Release

Handle

previous next