Filter
Top Products
7
OPERATION
OPENING
CLOSING
FIGURE 1- CLOSING/OPENING LEGS OF
BASE
OPERATING THE STAND UP LIFT
Closing/Opening Legs of Base (FIGURE 1)
The shifter handle is used to open or close the legs of the
base for stability when lifting a patient.
1. Stand at the rear of the stand up lift and grasp the
shifter handle with one (1) hand and place the oppo-
site hand on the push handle of the mast for balance.
NOTE: The shifter handle MUST lock into its mount-
ing slot to lock legs in the full open or closed position.
Legs of Base
Mounting Slot
Shifter Handle in Locked
CLOSED Position
Legs of
Base
Mounting
Slot
Shifter Handle in Locked
OPENED Position
O
P
E
R
A
T
I
O
N
OPERATION
FIGURE 2 - ATTACHING ELECTRIC ACTUATOR TO MAST
CLOSING.
1. Pull the shifter handle OUT and away from the
stand up lift and then to your LEFT until it LOCKS in
the notch of the bracket.
NOTE: Left is determined by standing behind the stand
up lift facing towards the front casters.
OPENING.
1. Pull the shifter handle OUT and away from the
stand up lift and then to your RIGHT until it LOCKS in
the notch of the bracket.
NOTE: Right is determined by standing behind the
stand up lift facing towards the front casters.
Locking/Unlocking the Rear Swivel
Casters (FIGURE 2)
1. Perform one (1) of the following:
A. LOCKING - Press DOWN on the BOTTOM of
the locking lever.
B. UNLOCKING - Press DOWN on the TOP of the
locking lever.
FIGURE 2 - LOCKING/UNLOCKING THE
REAR SWIVEL CASTERS
STEP HERE TO LOCK STEP HERE TO UNLOCK
Locking
Lever
Lift Arm
Mounting
Bracket
Electric
Actuator
Top Nut
Top
Bolt
Bushing
Bracket