Filter
Top Products
20
8. Slide the loose top half of the back cane through the
new back upholstery.
9. Using the mounted back cane as a guide, reinstall the
two (2) hex bolts that secure the top half of the back
cane to the bottom half of the back cane.
NOTE: Make sure the back canes are mounted to the
same height.
WARNING
The top and bottom half of the back canes
MUST be tightened securely together BE-
FORE using the wheelchair, otherwise in-
jury or damage may occur. Use Loctite 242
on the hex bolts and torque to 75-inch
pounds.
10. Use Loctite 242 on the hex bolts and torque into the
back canes to 75-inch pounds.
11. While holding the hex bolt, reinstall the locknut and
torque to 75-inch pounds.
12. Repeat STEP 11 for the other hex bolt and locknut.
13. Securely tighten the new back upholstery to the back
canes with the two (2) phillips screws and washers.
14. Secure the bottom of the new back upholstery to the
wheelchair frame with tie-wraps.
NOTE: Clean upholstery with warm DAMP cloth and mild
detergent to remove superficial soil.
WARNING
Laundering or moisture will reduce flame
retardation of the upholstery.
Washers
FIGURE 3 - REPLACING CAPTAIN'S SEAT
Hex Screws (Apply
Loctite 242)
Seat Frame
Assembly
Captain's Seat
REPLACING CAPTAIN'S SEAT
(FIGURE 3)
1. Remove the Captain's seat from the wheelchair. Refer
to REMOVING/INSTALLING CAPTAIN'S SEAT in PRO-
CEDURE 5 of the owner's manual part number
1080722.
2. Remove the four (4) hex screws and washers that
secure the existing captain's seat to the seat frame
assembly.
3. Line up mounting holes in the new captain's seat with
mounting holes in the seat frame assembly.
4. Apply Loctite 242 to the hex screws.
5. Install the four (4) hex screws and washers through
the seat frame assembly and into the new captain's
seat. Tighten securely.
6. Install the new captain's seat onto the wheelchair. Re-
fer to
REMOVING/INSTALLING CAPTAIN'S SEAT in
PROCEDURE 5 of the owner's manual, part number
1080722.
PROCEDURE 5 SEAT/BACK
S
E
A
T
/
B
A
C
K
Seat Frame
Assembly