Filter
Top Products
15
This Procedure Includes the Following:
Adjusting Flip-Up Removable Footboard
Adjusting the Removable Footboard
WARNING
After ANY adjustments, repair or service and
BEFORE use, make sure that all attaching
hardware is tightened securely - otherwise
injury or damage may result.
PROCEDURE 3
F
R
O
N
T
R
I
G
G
I
N
G
S
FRONT RIGGINGS
Flip Up Footboard
HEIGHT - MWD WHEELCHAIRS
Washer
Hex
Screw
Locknut
Footboard
Mounting
Bracket
FIGURE 1 - ADJUSTING FLIP-UP
REMOVABLE FOOTBOARD (ANGLE)
Caplug
Cap
Hex
Screw
Caplug
Washer
Wheelchair Frame
Footboard
Mounting
Bracket
Bushing
Seven (7)
Mounting
Positions
Footboard Pivot
ADJUSTING FLIP-UP REMOVABLE
FOOTBOARD
NOTE:This footboard assembly is located on models built
BEFORE 3/1/00. Refer to
ADJUSTING THE REMOV-
ABLE FOOTBOARD for the footboard assembly on
models built AFTER 3/1/00 in this procedure of the manual.
NOTE: The following procedures are for both FWD and
MWD wheelchairs, unless otherwise noted.
Angle (FIGURE 1)
NOTE: This procedure is for FWD wheelchair only.
NOTE: Angle availability is limited when the motors are in
the forward-most position.
1. Remove the caplug caps.
2. Remove the front hex screw and caplug washer that
secure the footboard mounting bracket and bushing
to the wheelchair.
3. Repeat STEPS 1-2 for the opposite front hex screw
and caplug washer.
4. Move the footboard mounting brackets to one (1) of
three (3) positions.
NOTE: To ensure the existing hex screws tighten securely,
apply Loctite 242
®
onto the threads.
5. Reinstall the two (2) hex screws and caplug washers
through the two (2) footboard mounting brackets and
bushings and into the wheelchair.
Footboard Pivot
FIGURE 2 - ADJUSTING FLIP-UP
REMOVABLE FOOTBOARD (HEIGHT)
Loctite - Registered Trademark of Loctite Corporation.
6. Torque the two (2) hex screws to 156-in/lbs.
7. Reinstall the two (2) caplug caps.
Height (FIGURE 2)
1. If necessary, remove the four (4) caplug caps.
2. Remove the hex screw, two (2) spacers, washers
and locknut that secure one (1) of the footboard pivots
to the footboard mounting bracket.
3. Repeat STEP 2 for opposite side of the wheelchair.
4. Move the footboard pivots to one (1) of the following:
MWD WHEELCHAIRS: one (1) of seven (7) positions.
FWD WHEELCHAIRS: one (1) of five (5) positions.
Flip Up Footboard
HEIGHT - FWD WHEELCHAIRS
Washer
Hex
Screw
Locknut
Footboard Mounting
Bracket
Five (5)
Mounting
Positions
Caplug
Cap