Filter
Top Products
Part No. 1090132 Rev F 49 Invacare Scooters
PROCEDURE 9SHROUD/WHEELS
REMOVING
1. Turn Power OFF and remove key from ignition.
2. Place the front of the powered scooter up on blocks so that the front wheel is OFF the ground.
3. Remove the hardware that secures the front wheel to the mounting fork/front
frame. The hardware for each model is as follows:
A. For ZOOM-3 and LYNX SX-3 - Mounting screw, washers and locknut.
B. For Lynx LX-3 and LX-3
Plus
- Hex head threaded insert, spacers, washer,
lockwasher, and locknut.
C. For PANTHER LX-4 and PANTHER MX-4 - Mounting screw, lockwasher,
washer (if applicable) and locknut.
4. Remove front wheel from mounting fork/front frame.
INSTALLING
1. Secure the wheel to the mounting fork/front frame in the following manner:
WARNING
Front wheel MUST be mounted in the bottom mounting hole For ZOOM-3
and LYNX SX-3. Otherwise, injury may result.
A. For ZOOM-3 and LYNX SX-3 - with mounting screw, washers, and locknut.
B. For LYNX LX-3 and LX-3
Plus
- with hex head threaded insert, spacers,
washer, lockwasher, and locknut.
C. For PANTHER LX-4 and PANTHER MX-4 - with mounting screw,
lockwasher, washer (if applicable) and locknut.
2. Securely tighten front wheel mounting hardware.
SHROUD/WHEELS
Mounting
Fork
Mounting
Screw
Locknut
Wheel
FIGURE 3 - REMOVING / INSTALLING THE FRONT WHEEL(S)
Washers
MODELS ZOOM-3 AND LYNX SX-3 MODELS LYNX LX-3 AND LX-3
Plus
MODELS PANTHER LX-4 AND PANTHER MX-4
Hex Head
Threaded
Insert
Spacer
Spacer
Washer
Lockwasher
Mounting
Screw
Washer
Panther (MX4)
Lockwasher
Mounting
Screw
Mounting
Fork
Wheel
Wheel
Front
Frame
DO NOT USE TOP
MOUNTING HOLE