Filter
Top Products
46 Part No. 1118395
®
OPTIONSSECTION 10
OPTIONS
INSTALLING/REMOVING THE CRUTCH/CANE
HOLDER (FIGURE 2)
NOTE: The Crutch/Cane Holder, Safety Flag, and Oxygen Holder all install into the accessory tube;
ONLY one (1) of these may be installed at a time.
NOTE: To remove, reverse the following procedure.
WARNING
The installation of the crutch/cane
holder onto the back of the scooter
seat significantly increases the length
of the scooter. When turning the
scooter or swiveling the scooter
seat, it is important to take note of
this increased length - otherwise,
injury and/or damage to the
surrounding property may result.
1. Install the crutch/cane holder into the
accessory tube located on the back of
the seat.
2. Install mounting knob to secure the crutch/cane holder in place. Securely tighten.
3. Align slot on base with hook on crutch/cane holder and slide base down into
position.
FIGURE 2 - REMOVING/
INSTALLING THE CRUTCH/CANE
HOLDER
Crutch/
Cane
Holder
Accessory
Tube
Hook
Seat
Base
Mounting
Knob
INSTALLING/REMOVING THE SAFETY FLAG (FIGURE 3)
NOTE: To remove, reverse the following procedure.
WARNING
The installation of the safety flag onto the back of the scooter seat
significantly increases the length of the scooter. When turning the scooter or
swiveling the scooter seat, it is important to take note of this increased length
- otherwise, injury and/or damage to the surrounding property may result.
INSTALLING
1. Install the bracket into the accessory
tube located on the back of the seat.
2. Install mounting knob to secure the
bracket in place. Securely tighten.
3. Install safety flag into bracket.
FIGURE 3 - REMOVING/
INSTALLING THE SAFETY FLAG
Accessory
Tube
Mounting
Knob
Bracket
Safety
Flag
Seat