Filter
Top Products
30 Part No. 1118395
®
REMOVING/INSTALLING SEAT POSITIONING STRAP
(FIGURE 5)
WARNING
ALWAYS wear your seat
positioning strap. Inasmuch as the
SEAT POSITIONING STRAP is an
option on this powered scooter
(you may order with or without the
Seat Positioning Strap), Invacare
strongly recommends ordering the
Seat Positioning Strap as an
additional safeguard for the
powered scooter user.
1. Remove the two (2) mounting screws
and washers that secure the seat
positioning straps to the arm frame.
2. Remove the two (2) halves of the seat
positioning strap from the arm frame.
3. Reposition the two (2) NEW seat positioning strap halves underneath arm frame.
4. Reinstall the two (2) mounting screws and washers that secure the seat positioning
straps to the arm frame. Securely tighten.
SECTION 4 SEAT ASSEMBLY
SEAT ASSEMBLY
90°
SEAT SWIVEL ADJUSTMENT (FIGURE 4)
WARNING
Ensure that seat is locked into the forward position BEFORE and DURING
operation of the scooter. Otherwise, injury to the user and/or damage to
the scooter may result.
CAUTION
DO NOT use the seat swivel option when accessories are installed (such as
safety flag, crutch/cane holder, etc.) and the seat is mounted in lowest
height adjustment position. Otherwise, damage to the scooter may occur.
1. The seat lever is located just
beneath the seat on the right side.
2. Pull the seat lever UP to rotate the
seat.
NOTE: The seat locks in position at 90°
intervals. The seat is locked when an audible
click is heard.
3. Rotate the seat to the desired
position.
4. Release seat lever to lock seat in
desired position.
Swivel Release Lever
(Lift UP to activate)
Seat
FIGURE 4 - 90° SEAT SWIVEL
ADJUSTMENT
NOTE: Seat swivels 360º
in either direction.
Seat
TOP VIEW
VIEW FROM
BACK
FIGURE 5 - REPLACING SEAT
POSITIONING STRAP
Arm
Frame
Seat
Positioning
Strap
Mounting Screw
Seat
Positioning
Strap
Washer
Mounting Screw
Washer