Filter
Top Products
SECTION 8—ARMS
300 and 400 40 Part No. 1118395
SECTION 8—ARMS
ƽ WARNING
After ANY adjustments, repair or service and BEFORE use, make sure all attaching
hardware is tightened securely - otherwise injury or damage may result.
Before performing any maintenance, adjustment or service, turn power OFF and
remove key from ignition.
REMOVING/INSTALLING/ADJUSTING ARMS
NOTE: For this procedure, refer to FIGURE 8.1.
REMOVING/INSTALLING
NOTE: Reverse this procedure to install the arms.
1. Loosen adjustment knob that secures the arm to the arm support bracket.
2. Remove the adjustable width arm from the arm support bracket.
3. If necessary, repeat STEPS 1-2 to remove the remaining arm.
FIGURE 8.1 - REMOVING/INSTALLING/ADJUSTING ARMS
ADJUSTING ARM WIDTH
NOTE: Changing the width of the arms may also effect the overall width of the powered scooter.
Use caution when traveling through doorways as the width may have increased.
1. Loosen the adjustment knob located beneath the seat frame on the arm support
bracket. Refer to FIGURE 8.1.
Arm
Arm Mounting Tube
Adjustment Knobs
Arm Support Bracket