Filter
Top Products
SECTION 5—WHEELCHAIR OPERATION
At’m 28 Part No. 1125035
MULTI FUNCTION CHARGER PORT
ƽ WARNING
Set-up/programming of the Electronic
Control Unit is to be performed only by
a qualified technician. The final adjust-
ments of the controller may affect other
activities of the wheelchair. Damage to
the equipment could occur under these
circumstances. If unqualified individuals
perform any work on these units, the
warranty is void.
FIGURE 5.2 - MULTI FUNCTION
CHARGER PORT
The multi function charger port is located at the front of the joystick housing. This
provides easy access for charging the wheelchair batteries. This port also serves as the
Remote Programmer Communication connection.
RESETTING THE CIRCUIT BREAKER
ƽ WARNING
NEVER defeat or bypass the circuit breaker. ONLY replace with a circuit breaker of
the same rating.
NOTE: For this procedure, refer to FIGURE 5.3.
1. Remove the battery pack from the wheelchair base. Refer to Removing/Installing the
Battery Pack on page 35.
2. Open the battery pack by performing the following -
A. Grasp the side flaps and pull up.
B. Grasp the front flap and pull up.
3. To reset - press the circuit breaker reset
button located inside the protector ring
on top of circuit breaker.
4. Close the battery pack by performing
the following -
A. Fold down the front flap and press
to engage the hook and loop straps.
B. Fold down the side flaps and press
to engage the hook and loop straps.
NOTE: Ensure that the hook and loop straps
are securely fastened before lifting the battery
pack.
FIGURE 5.3 - RESETTING THE
CIRCUIT BREAKER
Multi-Function
Charger Port
FRONT VIEW OF JOYSTICK
Circuit Breaker
Reset Button
Side Flap
Side Flap
Front Flap
Protector Ring