Invacare 636959 Oxygen Equipment User Manual


 
Aspirator Suction Unit 2 Part No 636959
ƽ WARNING
Proper operation of this product is necessary to avoid physical harm.
Improper use can cause personal injury and/or tissue damage. This
product should not be used unless the operator has been instructed by a
physician or other qualified health care professional.
DO NOT disassemble this unit. Disassembly or attempted repairs done
incorrectly can create an electrical shock hazard. Only qualified
technicians should perform servicing of this suction unit. Otherwise,
electrical shock or injury may occur.
To reduce the risk of burns, electrocution, fire or injury to persons:
Close supervision is necessary when this product is used by, on, or
near children or physically challenged individuals.
Use this product only for its intended use as described in this guide.
Never operate this product if it has a damaged power cord or plug,
if it is not working properly, if it has been dropped or damaged, or if
it has been dropped into water. Return the product to a service
center for examination and repair.
Keep the power cord away from heated surfaces.
Never use while drowsy or asleep.
Never drop or insert fingers or any other object into any openings.
Never block any air openings of the product or place it on a soft
surface where the opening may be blocked. Keep all air openings
free of lint, dirt, and other foreign objects.
DO NOT use outdoors or operate where aerosol (spray) products
are being used or where oxygen is being administered in a closed
environment such as an oxygen tent.
This unit is oil-less. DO NOT lubricate.
The motor of this compressor has a thermal overload protector. If
the motor overheats, the overload protector will shut off the
motor. Always disconnect power source before servicing.
All electrical products generate heat. To avoid injury, never touch
the motor housing during or immediately after operation.
Some attachments or accessories may not fit the tubing supplied. All
attachments or accessories should be checked prior to use to assure
proper fit.
The suction unit is used with a power supply allowing operation on AC
voltage (115VAC, 60 Hz). The correct power source must be used to
connect to adaptable wall power.