Support User Manuals

Invacare 1200 Personal Lift User Manual

Open as PDF

of 36

USING THE SCALE

Part No. 1150696 23 Traverse Lift/Transporter

Calibrating the 1100 Bath Scale

NOTE:Forthispr ocedur e, refertoFIGURE 3.1onpage20andFIGURE 3.4.

1. ThepatientMU STberemovedfromthebathlifttoproperlycalibratethebathscale.Refer

toTransferringin to/outoftheLiftoftheBathLi ftOw ner’s Manualforinstructions.

2. Removethe seat/stretcherfromthebathlift.

•Lockthetw orear lockingcasters.

•Presson thedown arrowonthehandpendanttolow erthebathlift.

•Removethe threeboltsthatsecurethehangerrodstothebathscale.

•Pullthehangerrodsaway fromthepatientscaletoremov etheseatorstre tcherfrom

thebathlift.

3. Removethe fourscrewsthatattachthecov ertotheba thscale.

NOTE:TheRUN/CALswitchislocat ednexttothedisplaywindowandis visibleafterthecover is

removed.

4. SlidetheswitchmarkedRUN/CALtotheCALposition.

5. AdjustR9sothe displayindicates+15poundoffset.Re fertoDetail“A ”ofFIGURE3.4.

6. ReverseSTEP2toattachthese atorstretchertothebathlift.

7. Makenoteoftheweightoftheseatorstretcheronthedisplay.

8. Put200poundsof calibratedweightontheseatorstretcher.Checkfor theproperweight

increaserelativetotheweightoftheseatorstretchernotedinSTEP7.

9. AdjustR18untilth eweightonthedisplayisaccurateofthecombinedweightofthe

calibratedweightandtheweightoftheseatorstretcher.Refer toDetail“A ”ofFIGURE 3.4.

10. Removethe calibratedweightfromthebathscale.RepeatSTEPS5‐9asnecessary.

11. SlidetheRUN/CALswitchtotheRUNposition.PresstheZERObutton.

12. Whenthedispl aywindowreads0.0,placethecalibratedweightontheseatorstretcher

andmakesuretheweightonthe displ ayiscorrect.

13. Removethe calibratedweightfromthebathscale.

NOTE:Thebathscaleisreadyforuse.

FIGURE 3.4 Calibrating the 1100 Bath Scale

Screw

(1 of 4)

Cover

R9 Adjustment Screw

R18 Adjustment Screw

DETAIL “A” - 1100 BATH SCALE CIRCUIT BOARD

previous next