Filter
Top Products
System Release 6.0 cPCI Feature Pack 1 for Windows — September 2004 11
3
3.New Features by Product
This chapter describes the key features for the following Intel
®
NetStructure™ boards
supported in Intel
®
Dialogic
®
System Release 6.0 cPCI Feature Pack 1 for Windows:
• New Intel NetStructure DMT160TEC Board . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
• New Intel NetStructure IPT10000C IP Board . . . . . . . . . . . . . . . . . . . . . . . . . . 12
• New Intel NetStructure SIU520, SIU231 and SIU131 Signaling Interface Units12
• New Intel NetStructure CPM8 SS7 Signaling Board . . . . . . . . . . . . . . . . . . . . 12
• New Features for Intel Netstructure DM/IP Series Products . . . . . . . . . . . . . . 13
• New Features for Intel NetStructure DM/V and DM/V-A Boards . . . . . . . . . . . 14
• New Features for Intel NetStructure IPT Series Products . . . . . . . . . . . . . . . . 15
3.1 New Intel NetStructure DMT160TEC Board
This release introduces support for the Intel
®
NetStructure™ DMT160TEC. The Intel
NetStructure DMT160TEC network interface board is a high-density, digital telephone
interface on a CompactPCI* form factor. This board supports up to 16 spans or 480 ports,
and is programmable as T1, E1, or a mix of both (in units of four spans). The Intel
NetStructure DMT160TEC is new board that was not available previously in Intel Dialogic
System Release 6.0 for cPCI on Windows 2000.
Features
The following features are supported in Intel Dialogic System Release 6.0 cPCI Feature
Pack 1 for Windows. These features are new since Intel Dialogic System Release 6.0 for
cPCI on Windows 2000.
• CAS support including all PDK protocols
• Tone Detection and Generation including GTD/GTG
• Ability to dynamically configure the following trunk parameters at runtime:
– CRC4 ON/OFF
– Selecting between user and network modes
• Clear Channel support for T1 and E1
• Ability to query Layer 1 statistics
• Ability to enable/disable D-Channel without having to bring the entire system down
• Ability to reconfigure trunks between ISDN and Clear Channel on both DMN160TEC
and DMT160TEC
Note: This feature requires new PCD files, user modifications to configuraton files
and re-initialization of the board.