Filter
Top Products
Page 7For technical questions, please call 1-800-444-3353.SKU 67437
Adjusting Foot Rests
To adjust the Foot Rests, loosen but 1.
don’t remove the bolt that secures the
lower section of each Foot Rest to
the upper half. See Figure 2, below.
Reposition lower section of Foot Rest 2.
to desired height. Tighten bolt until
upper section is secured at spot.
NOTE:3. The Wheelchair may be used
without Foot Rests by persons able to
use their feet to self-propel chair.
Replacing Seat
Wheelchair uses ten screws and 1.
washers to secure Seat (6) to frame.
To replace the Seat, remove the 2.
screws and washers that secure the
Seat to the cross braces. See Figure
3, above. Please Note: Seat height
cannot be adjusted.
Remove plate from Seat sleeve.3.
To install new Seat, insert plate into 4.
sleeve and fasten Seat to cross bars
using ten screws and washers.
Replacing Back Pad
Remove the eight screws and 1.
washers that secure the Back Pad (7)
to the back of the Handles (8).
Remove upholstery from Wheelchair 2.
and, using the screws and washers,
securely fasten the new back
upholstery to the back of the Handles.
See Figure 4, below.
Adjust and Replacing Front
Wheels
Should the Casters need to be 1.
adjusted, rst tip back of Wheelchair
to oor.
To tighten or loosen Casters, remove 2.
the Dust Cover from the top of the
Caster Head tube and adjust Locknut
allowing for looser or tighter Caster
Figure 2
Bolt
Upper Foot
Rest
Lower Foot
Rest
Figure 3
Seat
Screws and
Washers
Figure 4
Handles
Back Pad
(7)
Screws
Washers