Filter
Top Products
Page 6For technical questions, please call 1-800-444-3353.SKU 67437
SPECIFICATIONS
Weight Capacity 250 lb.
Wheelchair Width 24”
Weight 40 lb.
Wheels
Solid Rubber Tires and
360° Swivel Casters
Seat Width 20-1/4” x 16-5/8” Deep
UNPACKING
When unpacking, make sure item
is intact and undamaged. If parts are
missing or broken, call Harbor Freight
Tools at 1-800-444-3353.
ASSEMBLY/OPERATIONS
INSTRUCTIONS
Read the ENTIRE IMPORTANT
SAFETY INFORMATION
section at the beginning of this
manual including all text under
subheadings therein before set
up or use of this product.
For additional information
regarding the parts listed in the
following pages, refer to Assembly
Diagram near the end of manual.
Unfolding/Folding
Before unfolding Wheelchair, make 1.
sure Rear Wheels (3) are in the
locked position.
Hold the Armrests (10) and pull them 2.
away from one another, unfolding the
Wheelchair.
As Wheelchair unfolds, press down 3.
on Seat (6).
Swivel Footplates (2) so they are 4.
horizontal.
To fold the Wheelchair, lock the Rear 5.
Wheels and fold Footplates up.
Pull up on the Seat and push 6.
Armrest closer together, folding the
Wheelchair.
Installing Foot Rests
Slide the Footplates (2) to the side 1.
(so that they are perpendicular to the
Wheelchair. See Figure 1, below.
Install the end of each Detachable 2.
Footrest (1) onto the tab extending
from the Wheelchair Frame (9). See
Figure 1, above.
Swivel the Footrest towards the 3.
inside of the Wheel Chair until it locks
into place.
Please note: When properly installed, 4.
Footplate will be on the inside of the
Wheel Chair when locked into place.
To remove, push the Control Handle 5.
out and lift the Foot Rest off the
Wheelchair. See Figure 1, above.
Footplate (2)
Foot Rest (1)
Control
Handle
Tab
Figure 1