Filter
Top Products
2D:4>6C:42?#65:42=&C@5F4ED25:G:D:@?@762=E9&C@5F4ED?4K#2EC:IK(,#2?F2= &
ssembly - standard head and foot boards
A
1. Assemble two Mounting Tubes (#4) to the Headboard (#1) and two to the Footboard (#2) using eight 1/4-20 x 4mm
JCB-B Hex Drive Bolts (#6), going through the pre-drilled holes on the boards and into the eight 1/4-20 x .60” Long
Threaded Inserts (#3) (already attached to the boards) as shown. Hand tighten only at this time.
2. Insert the Mounting Tubes into the Main Bed Frame Tubes so that the holes match up as shown. Secure with four
5/16 x 1-1/2” Clevis Pins (#7) and 1-9/16 Hair Pin Clips (#8) (1 each per bed frame tube). The mounting tubes will
slide underneath the two 5/16-18 x 1.50” Carriage bolts that were pre-inserted into the Main Frame Rails at the
head-end of the bed by the manufacturer.
3. Now tighten all screws with a phillips screwdriver. Be careful not to overtighten.
* There are a number of stylish options for Matrix II Headboards and Footboards including Oak, Walnut, and
Mahogany finishes. Please consult your catalog, our website (www.graham-field.com), or contact one of our Sales
Representatives for options. Please note that headboards and footboards come as a kit and are not interchangeable.
Item # Quantity Part # Description
11 - Headboard*
2 1 - Footboard*
3 8 100-7025-004
1/4-20 UNC x .60” Long Threaded Insert
(pre-inserted into footboard and headboard)
Headboard & Footboard Mounting Kit (999-0775-000) includes the following parts:
4 4 999-0746-035G Mounting Tubes
5 4 100-4700-015 1” x 1” Square Tube End Cap (pre-inserted in tubes)
6 8 100-5425-094 1/4-20 x 4mm JCB-B Hex Drive Bolt
7 4 100-7931-007 Clevis Pin - 5/16 x 1-1/2” w/cross hole
8 4 100-2001-006 1-9/16 Hair Pin Clip
not shown 1 100-9900-060 M4 4mm Hex Allen Wrench
Hardware Pre-inserted into Main Frame Rails to Hold Mounting Tubes
9 2 100-5231-003 5/16-18 x 1.50” Carriage Bolt
10 2 100-6731-006 5/16-18 Thin Nylon Lock Nut