Filter
Top Products
LF1031-INS-LAB-RevD12
9
ASSEMBLY
Base and mast assembly
1. Remove the locking pin from the mast sleeve located on the rear of
the base.
2. Install the L-inserts in the base.
3. With the boom pointed in the same direction as the base legs, insert
the mast into the sleeve.
4. Insert the locking pin through the holes of the sleeve and mast.
5. Secure the locking pin by attaching the locking cable to the other
end of the locking pin.
6. Screw the two mast attachment bolts into the holes in the sleeve of
the base.
7. Use the supplied hex wrench to tighten the bolts.
remove locking pin
install L-inserts
install locking pin
secure locking pin
install mast bolts