Filter
Top Products
LF1031-INS-LAB-RevD12
11
LF1041 only: attaching
actuator / motor,
power bracket,
components
Tools needed: Phillips screwdriver,
M3 hex key
1. Attach actuator / motor to
boom and mast using the
pre-attached bolts as shown
at near right; note that
illustration shows mounting
points after assembly; shown
components will not yet be present.
2. Use Phillips screwdriver to remove the three Phillips
heads screws on the back of the mast. Position power
bracket on mast as shown at upper far right. Secure
power bracket to mast by installing the Phillips head
mast screws as shown at upper far right (top screw is
shown). Use Phillips screwdriver to tighten.
3. Mount control box on mast by sliding its lower end onto
power bracket lip, as shown at near right. Secure control
box by installing socket head cap screw at top of control
box, as shown at far right. Use M3 hex key to tighten.
4. Mount battery charger on mast by sliding it onto power
bracket lip so it rests on top of control box. Secure
battery charger by installing socket head cap screw at
top of battery charger, as shown at right. Use M3 hex key
to tighten.
5. Mount battery to mast by sliding it onto top power
bracket lip so it rests on top of battery charger, and boss
on battery back ts into power bracket hole.
6. The control box, battery charger, and battery are shown
correctly mounted on the mast at right.
7. Continue to next page for electrical power connections.
Phillips head screw
mast
control box
control box
battery
battery
battery boss
power bracket hole
socket head
cap screw
socket head cap screw
battery
charger
power bracket
secure
control box
secure
battery charger
mount
control box
mount battery
power
components
mounted
mount
power bracket
secure
power bracket
mast
boom
mounting
points
attach
actuator / motor
to boom and mast