Filter
Top Products
•
Components and heater lifetime can be shortened by continuous high
temperature operation.
•
Most probes have handle temperature limits. Be sure that the probe handle
temperature limit is not exceeded in the air above the unit.
•
(9107 only) Always use the well insulator, see Section 5.4.
•
Allow for test probe expansion inside the well as the dry-well heats.
•
DO NOT use fluids to clean out the well.
•
Never introduce any foreign material into the probe hole of the insert.
Fluids, etc. can leak into the calibrator causing damage.
•
DO NOT change the values of the calibration constants from the factory
set values. The correct setting of these parameters is important to the
safety and proper operation of the calibrator.
•
DO NOT slam the probe stems in to the well. This type of action can
cause a shock to the sensor and affect the calibration.
• DO use a ground fault interrupt device.
1.3 Hart Scientific Authorized Service Centers
Please contact one of the following authorized Service Centers to coordinate
service on your Hart product:
Hart Scientific, Inc.
799 E. Utah Valley Drive
American Fork, UT 84003-9775
USA
Phone: +1.801.763.1600
Telefax: +1.801.763.1010
E-mail: support@hartscientific.com
Fluke Nederland B.V.
Customer Support Services
Science Park Eindhoven 5108
5692 EC Son
NETHERLANDS
Phone: +31-402-675300
9105/9107 5
1 Before You Start