Filter
Top Products
WARNING: The footplates' lowest point should be no closer to
the ground than 2
1
/2 inches, to permit proper clearance.
WARNING: Do not stand on the footplates; this could cause the
wheelchair to tip.
M13 wrench
1. Traveler HTC front
rigging (elevating
legrests or optional
footrests) are equipped
with anti-theft nuts,
shown at right. Use an
M13 wrench to remove
them.
2. To release lock, pull
swingaway release lever
forward, toward front of wheelchair. Legrest will swing outward.
3. To remove, lift legrest straight up off hinge pin bolt.
M13 wrench
1. Set legrest on wheelchair frame (so that legrest hinge plates
engage hinge pin bolts).
2. Swing legrest inward.
3. Use an M13 wrench to attach anti-theft nuts.
4. Ensure that legrests are locked in place and that swingaway release
levers are locked in a rearward position, toward back of wheelchair.
WARNING: Ensure that front rigging is locked in place before
occupying or operating wheelchair.
nut
hinge
plate
swingaway
release lever
remove elevating legrest /
optional footrest