Filter
Top Products
4.16 Purge Adjusting Valve
(Models LS2070 and LS2580)
WARNING!
Ensure that the dryer is de-energized, valve isolated
and fully depressurized before attempting to remove
or disassemble any dryer component or subassem-
bly. Failure to do so may result in serious personal
injury and/or equipment damage.
Note: Removal of valve body [4] is not required unless
replacement of valve body is necessary.
1. Clean and inspect all valve hardware upon
disassembly. Replace all software and any
hardware which appears damaged or abnormally
worn.
2. Apply an ultra-thin film of O-ring lubricant to item [2]
before reassembly.
Figure 4.17
1
2
3
2
4
1
Item Description Total
1 Retaining Ring 1
2 O-ring 2
3 Valve Stem 1
4 Valve Body 1