Filter
Top Products
Revised 1-8-2007
5
Handling and Installation of Your TM Series Cooling Tower
On -Site Inspection
Upon arrival at the job site, carefully inspect the shipment for any damage. If shipping damage has occurred,
notify the driver or the carrier immediately and make a notation of the damage on the shipping bill of lading.
Check that all items listed B/L have been received.
Offloading
The TM Series cooling towers are normally delivered to the site on a 30 inch high drop deck trailer. Both the
tower body assembly and sump assembly are strapped down to the truck bed. The sump assembly should be
unloaded first.
Lifting with crane:
• Use fabric slings of sufficient strength for better load distribution and protection of the plastic tower
body.
• Wrap slings underneath tower sump assembly to lift and set into place.
• Lift tower body by attaching slings, kept separate by spreader bars, to the four lifting bars as shown
below.
• Spreader bars must be used to lift vertically on the lifting bar. Above the spreader bars use adequate
length straps specifically designed for vertical lifting in order to maintain an angle of 60° or less between
slings.
Liftin
g
Bar